How to change the brake pads on the handbrake: Popular topics and practical tutorials on the entire network
Recently, the topic of car maintenance has become popular on major social platforms, especially the tutorial on DIY brake pad replacement has sparked widespread discussion. This article combines hot search data in the past 10 days to sort out popular car repair topics across the network for you and attaches themHandbrake replacement brake padsdetailed guide.
1. Top 5 popular topics in automobiles across the entire network (next 10 days)
| Ranking | topic | Popularity index | Main Platforms |
|---|---|---|---|
| 1 | Guide to avoid pits in maintenance of new energy vehicles | 98,000 | TikTok/Zhihu |
| 2 | Tutorial for replacing brake pads by yourself | 72,000 | B station/Quick Shou |
| 3 | Interpretation of the new regulations on annual automobile inspection | 65,000 | Weibo/Toutiao |
| 4 | Recommended list of car goodies | 51,000 | Little Red Book |
| 5 | Safety tips for driving in rainy season | 43,000 | WeChat official account |
2. The entire process of handbrake replacement brake pads
Step 1: Preparation
• Tools required: jack, wrench set, C-clip, new brake pad
• Safety tips: Make sure the vehicle is on flat ground, tighten the handbrake and gear up
Step 2: Remove the tires
After lifting the vehicle with a jack, loosen the tire screws first, and then remove the tire completely. It is recommended to use tire mats on the bottom of the car as an additional safety guarantee.
Step 3: Disassemble the brake pump
Use a 12mm wrench to remove the fixing bolts of the split pump and be careful not to damage the oil pipe. Gently hang the sub-pump to avoid stress on the oil pipe.
Step 4: Replace the brake pads
After removing the old brake pads, press the piston back to its original position with a C-clip (note that the brake oil pot liquid level rises). Make sure the sound silencer is in the correct orientation when installing new brake pads.
Key data comparison table:
| project | Original brake pads | Sub-factory brake pads |
|---|---|---|
| Thickness standard | 10-12mm | 8-10mm |
| Service life span | 30,000-50,000 kilometers | 20,000-30,000 kilometers |
| Market price | 300-600 yuan per set | 150-300 yuan/set |
Step 5: Reset and Test
After replacing the sub-pump, you need to press the brake multiple times until the pedal becomes hard. The brake effect should be tested at low speed when driving for the first time, and the new brake pads require a 200-kilometer running-in period.
3. Frequently Asked Questions
Q: How to determine if the brake pads need to be replaced?
A: It should be replaced immediately when the following situations occur:
1. The sound of metal friction during brake
2. The brake distance has increased significantly
3. Thickness detection is less than 3mm
Q: What should I do if the brake becomes soft after replacement?
A: Possible reasons include:
1. The brake system is not exhausted correctly
2. The brake oil has too high moisture content
3. The piston of the sub-pump is not fully reset
It is recommended to go to a professional maintenance site for inspection immediately.
4. Things to note
• The rear wheel handbrake system is more complicated, and it is recommended that the operator watch the detailed video tutorial for the first time
• Electronic handbrake models require dedicated decoder reset
• Avoid sudden brakes within 300 kilometers after replacement
• It is recommended to check the brake disc wear at the same time
According to a survey data from a certain automobile forum, 83% of car owners expressed their willingness to try DIY to replace brake pads, but the actual operation success rate was only 61%. It is recommended that novices practice under the guidance of professionals first, or choose to replace them in the store (the average market price is 150-300 yuan/axle).
check the details
check the details
en
